P2 Heatsink To Celeron
Conversion
Begin by removing the fans off the VEK 12. A simple
Phillips screwdriver is all you need to do this. Don't forget, it's always nice to have a
clean work surface.
Once the fans are off you can do the removal of the
Pentium II mounting clips. Since we're using the VEK 12 on a Celeron we won't need those
clips anymore.
Take your Celeron and line it up with the heatsink like
the above photo. Use the Celeron mounting holes as a guide to tap some starter holes. Then
take the drill and drill the holes out. Just take it slow and easy and all will be fine.
Now it's time to put the tap into action. For those
that don't know, the tap makes the threads that the bolts will screw into. Notice that the
4 holes on the heatsink lines up with the 4 holes of the Celeron.
Next page: Putting it together
|
