!!
CPU Soft Menu II !!
|
LABEL |
SUGGESTED SETTINGS
|
NOTES |
| CPU Operating
Speed |
User Define |
|
| - Turbo
Frequency |
Enabled for 3%
more speed |
Only works on
66mhz and 100mhz |
| - Ext. Clock (PCI) |
Start at CPU
rating (66 or 100), then work up from there, 1 step at a time |
If computer
locks, reset to lower setting |
| - Multiplier
Factor |
CPU default
|
Most CPU's are
locked, so this will not affect anything |
| - SEL 100/66#
Signal |
Low |
Originally
intended for unlocking Pre August 1998 Pentium II 350 and 400mhz cpu's.
However, the Low setting has SLIGHTLY faster timing. |
| - AGPCLK/CPUCLK |
1/1 for under
100mhz FSB, 2/3 at or above 100mhz FSB |
Some AGP cards
can take 100+mhz AGP, however, there is little to no benefit, and greatly
increases the chance of shorting out your AGP card. |
| - L2 cache
Latency |
Low as possible
before reaching instability |
Above 8 will
shut L2 cache off on Pentium III CPU's |
| - Speed Error
Hold |
Disabled |
Very important
when overclocking |
| CPU Power
Supply |
User Define |
|
| - Core Voltage |
Klamath CPU's:
2.8
Deschutes P2's: 2.0
Celeron's: 2.0
P3's: 2.0 |
Start at these
default voltages, and go up 1 step at a time until either stability is
reached or 15% above spec. If stability is not reached, lower FSB speed |
Next page: BIOS Features Setup Menu
